Fluke 62 MAX+. Small in size. Big on toughness.

• Dust and water-resistant: IP54 rated.
• Rugged: 3-meter (9.8-foot) drop tested.
• Ergonomically designed: Completely redesigned for a more natural hand fit.
• Distance to spot: 12:1.
• Dual lasers: Identifies area to be measured.
• Large, backlit display: Makes data easier to read, even in dark areas.

Fluke 323 True-rms Clamp Meter.Rugged. Reliable. Precise.

• 400 A AC current measurement.
• 600 VAC and DC voltage measurement.
• True RMS AC voltage and current for accurate measurements on non-linear signals.
• Resistance measurement up to 40 kΩ with continuity detection.
• Slim, ergonomic design.
• CAT IV 300V/CAT III 600 V safety rating.

Fluke 1AC II VoltAlert™ Voltage Detector

• Voltbeat™ technology and continuous self-test, so always know it’s working.
• Upon detection, tip glows and beeper sounds.
• Voltage detection of 90 to 1000 VAC.
• CAT IV 1000 V for added protection.

Fluke C115 Soft Case

• Lightweight soft case to provide optimal protection and accessory storage.

Fluke 789 Temperature Kit features:

• Unique new wireless measurement logging capability
• Temperature measurement from -200 °C to 1372 °C using the t3000 FC
• 24 V Loop power supply
• HART mode setting with loop power (adds 250 ohm resistor)
• 100% larger dual display
• 1200 ohm drive capability on mA source
• Enhanced backlight with two brightness settings
• 0% to 100% mA Span Check buttons to toggle between 4 and 20 mA
• Infrared I/O serial port compatible with
• FlukeView® Forms Software Version 2.1
• Externally accessible fuses for easy replacement

These 787 features are also included in the 789:

• DMM designed to meet 1000 volt IEC 1010 CAT III standards
• Precision 1000 V, 440 mA True-RMS digital multimeter
• Frequency measurement to 20 kHz
• Min/Max/Average/Hold/Relative modes
• Diode test and continuity beeper
• Simultaneous mA and% of scale readout
• 20 mA DC current source/loop calibrator/ simulator
• Manual Step (100%, 25%, Coarse, Fine) plus Auto Step and Auto Ramp
• Externally accessible battery for easy battery changes

Fluke 789 Temperature Kit features:

• Unique new wireless measurement logging capability
• Temperature measurement from -200 °C to 1372 °C using the t3000 FC
• 24 V Loop power supply
• HART mode setting with loop power (adds 250 ohm resistor)
• 100% larger dual display
• 1200 ohm drive capability on mA source
• Enhanced backlight with two brightness settings
• 0% to 100% mA Span Check buttons to toggle between 4 and 20 mA
• Infrared I/O serial port compatible with
• FlukeView® Forms Software Version 2.1
• Externally accessible fuses for easy replacement

These 787 features are also included in the 789:

• DMM designed to meet 1000 volt IEC 1010 CAT III standards
• Precision 1000 V, 440 mA True-RMS digital multimeter
• Frequency measurement to 20 kHz
• Min/Max/Average/Hold/Relative modes
• Diode test and continuity beeper
• Simultaneous mA and% of scale readout
• 20 mA DC current source/loop calibrator/ simulator
• Manual Step (100%, 25%, Coarse, Fine) plus Auto Step and Auto Ramp
• Externally accessible battery for easy battery changes