Visit
Official Website

Mobicon - Remote Electronic Sdn Bhd
19, Jalan PJS 3/59,
Taman Sri Manja,
46000 Petaling Jaya,
Selangor, Malaysia.

+603-7783 2257
+603-7783 4316
+603-7783 4318

WALSIN Selangor, Malaysia, Kuala Lumpur (KL), Petaling Jaya (PJ)

1 - 24 of 45

WALSIN GENERAL PURPOSE CAPS

0201 to 1812 Sizes
NP0, X5R, X7R, Y5V, X6S, X7S
0.1pF~220uF
6.3V~100V

WALSIN SAW FILTER

Fixed spec.
For GPS/LTE/WALAN use
Walsin offers following product types: Single Saw, Single Saw Diplexer, Single Saw Duplexer, and Balanced Saw Duplexer

WALSIN SMD Unshielded Power Inductor / WLSN Series

SMD Unshielded Power Inductor / WLSN Series
   
Size:3.3*3.0*2.1mm Size:4.3*4*3.2 mm
Range:1uH ~ 470uH Range:1uH ~ 330uH
Tolerance:±10%~±20% Tolerance:±10%~±20%
   
Size:5.8*5.2*4.5mm Size:7.8*7*3.5mm
Range:1uH ~ 270uH Range:10uH ~ 330uH
Tolerance:±10%~±20% Tolerance:±10%~±20%
   
Size:7.8*7*5mm Size:13*9.4*5.21mm
Range:6.8uH ~ 4700uH Range:1uH ~ 4700uH
Tolerance:±10%~±20% Tolerance:±10%~±20%
   
Size:10*9*4mm Size:10.9*5.4mm
Range:1uH ~ 4700uH Range:1uH ~ 4700uH
Tolerance:±10%~±20% Tolerance:±10%~±20%

WALSIN SMD Wire Wound Power Inductor / WLPN Series

SMD Wire Wound Power Inductor (Resin Shielded) / WLPN Series
 
Size:2.0*2.0*1.2 mm
 
Size:3.0*3.0*1 mm
Range: 1uH ~ 4.7 uH Range: 1.2uH ~ 22 uH
Tolerance:±20%~±30% Tolerance:±20%~±30%
   
 
Size:3.0*3.0*1.5 mm
 
Size: 4.0*4.0*1.0 mm
Range: 1uH ~ 100 uH Range: 1uH ~ 22 uH
Tolerance:±20%~±30% Tolerance:±20%~±30%
   
 
Size: 4.0*4.0*1.8 mm
 
Size:5.0*5.0*1.0 mm
Range: 1uH ~ 22 uH Range: 1uH ~ 22 uH
Tolerance:±20%~±30% Tolerance:±20%~±30%
   
 
Size:5.0*5.0*2.0 mm
 
Size:5.0*5.0*4.0 mm
Range: 1uH ~ 22 uH Range: 1.5uH ~ 4.7 uH
Tolerance:±20%~±30% Tolerance:±20%~±30%
   
 
Size:6.0*6.0*1.0 mm
 
Size:6.0*6.0*2.8 mm
Range: 1.5uH ~ 22 uH Range: 1.5uH ~ 4.7 uH
Tolerance:±20%~±30% Tolerance:±20%~±30%
   
 
Size:6.0*6.0*4.5 mm
 
Size:8.0*8.0*4.2 mm
Range: 1.5uH ~ 4.7 uH Range: 1.5uH ~ 4.7 uH
Tolerance:±20%~±30% Tolerance:±20%~±30%

WALSIN Class III SEMI-CONDUCTIVE

  • Capacitance Range : 100,000pF
  • Capacitance Tolerance : +80%-20%
  • Operating Temperature Range : -25°C ~ +85°C
  • Rated Voltage : 16,25 & 50 VDC
  • Dissipation Factor(tanδ) : Y5V 16V….. tan δ ≤7.5%, Y5V 25/50V….. tan δ ≤5.0%
  • Insulation Resistance(IR)@25°C : 16V ….. ..100MΩ Minimum or 10MΩμF 25/50V…1000MΩ Minimum or 20MΩμF
  • Dielectric Strength : 2 times the rated WVDC
  • Testing Parameters : 1KHz ±20%, 0.1Vrms Maximum

WALSIN High Q & Low ESR Caps_(HH series)

High Q / Low ESR
0201 to 0805 Sizes
NPO
0.1pF~3300pF
10V~630V

WALSIN Feed Through (3-terminal) Caps_(FT series)

0805 Size
X7R
10nF~1uF
10V ~ 50V

WALSIN Chip Attenuator

Chip Attenuator (Convex, Π type)

4P3R, 0402*3,
0 ~ 20dB, (Convex, Π type)

WALSIN Cable Assembly

Cable Assembly > Low loss.

Good impedance. > Cable Options

  • RG-316, RG-178, RG-174, OD:1.13, OD:1.37
Connector Options
  • SMA, N type, IPEX, MCX, SMC

WALSIN Multilayer Ferrite Chip Inductor / WLFI Series

Size:1608~2012
Range:0.047uH ~ 10uH
Tolerance:±20%

WALSIN SMD Ferrite Chip Bead (AEC-Q200)/ WQBD Series

Size: 0603~4516
Tolerance:±25%
Range:10Ω~ 2500Ω

WALSIN Automotive Caps (MT Series)

Automotive Caps Qualified to AEC-Q200 (MT series)

AEC-Q200
0201 to 1210
NPO, X7R
0.1pF~2.2uF
10V~1000V


WALSIN ANTENNA SWITCH MODULE

Fixed spec.

For LTE / Wi-Fi use. > Product Type : MIPI control interface with Alliance standard.

1.Low loss,low distortion,and High isolation
2.RoHS Compliance
3.Integrated MIPI RFFE Slave Controller
4.Package is manufactured in LGA
5.Electrostatic Sensitive Device
6.Moisture Sensitive Level

 

WALSIN ANTENNA SWITCH

Fixed spec

 
For LTE / Wi-Fi use. > Product Type : GPIO contol interface or MIPI control interface with Alliance standard.

1.Low loss,and High isolation
2.RoHS Compliance
3.Small package is manufactured in LGA or QFN
4.Electrostatic Sensitive Device
5.Moisture Sensitive Level


WALSIN High Power Metal Current Sensor (TTU Series)

High Power Ultra Low Ohmic Metal Current Sensor /TTU Series

Ultra Low Ohmic with high power Current Sensor
Size: 2512
TCR: 50ppm ~ 100ppm
Tolerance: 1% ~ 5%
Power rating: 2W ~ 3W

 


WALSIN High Power & Low TCR Current Sensor (TTL Series)

Ultra Low Ohmic Current Sensor

Size: 0201 ~ 2512
TCR: 50ppm ~ 350ppm
Tolerance: 0.5% ~ 5%
Power rating: 1/10W ~ 2W

WALSIN Film Low Ohm Current Sense Chip-Resistor (0402)

Thick Film Low Ohm Current Sense Chip-Resistor

 

0402 – 2512, 0.01 – 0.976ohm,
±5%, ±1%, TC200 – 1500


WALSIN High Precision Thick Film chip resistor TC100

High Precision Thick Film chip resistor TC100

0402 – 2512, 10 -1Mohm,
±0.5%, ±0.1%, TC100


WALSIN Low Profile Caps_(TT series)

Low Profile
0402 to 1210 Sizes
X7R, X5R & Y5V
0.22μF~22μF
10V~100V

WALSIN ESD Protection at Hi-Speed Application(VH Series)

Storage Temperature : -40°C to +125°C
Operating Temperature : -40°C to +125°C
Maximum Clamping voltage : 34Vc~240Vc@1A, 8*20 us standard current.
Maximum Capacitance : 0.8pF~100pF @ 1 MHz.

WALSIN SURGE PROTECTION (VZ SERIES)

Storage Temperature : -40°C to +125°C
Operating Temperature : -40°C to +125°C
Maximum Clamping voltage : 20Vc~270Vc@1 A, 8*20 us standard current.
Maximum Capacitance : 3.5pF~10500pF @ 1 KHz.

WALSIN SMD FERRITE CHIP BEAD / WLBD SERIES

Features

1. General purpose bead for any electronic device.
2. Multi-Layer Process with high stability in reflow process
3. Standard Chip size


Size: 1005~4532
Tolerance:±25%
Range:22Ω~ 2500Ω

 

WALSIN DISC CAPACITOR (AC SERIES)

  • Capacitance Tolerance : ±0.25pF, ±0. 5pF, ±5%, ±10%, ±20%
  • Operating Temperature Range : -40°C ~ +125°C
  • Temperature Coefficient(C Max) : -1000~+350ppml°C (SL). ±10%(Y5P), +30~80%(Y5V), +20~55% (Y5U)
  • Voltage Resistance :
  • AH Type: X1: 400Vac / Y1: 400Vac or 250Vac
  • AC Type: X1 : 400Vac or 440Vac / Y2 : 250VaC or 300Vac
  • AS Type: X1 : 760Vac / Y1 : 500Vac
  • Dissipation Factor(tan δ) : SL: 30pF & above: Q≥ 1000, Below 30pF: Q≥400+20xC
  • @20°C, 1MHz, 1±0.2Vrms
  • Y5P: tanδ=2.5% Max. @20°C, 1KHz, 1±0.2Vrms
  • Y5U: tanδ=2.5% Max. @20°C, 1KHz, 1±0.2Vrms
  • Y5V: tanδ=5.0% Max. @ 20°C, 1KHz, 1±0.2Vrms
  • Insulation Resistance : 10000MΩ @500VDC, 60sec
  • Dielectric Strength : 1500Vac for 60sec(AC TYPE)(For Lead Pitch=5.0mm)
  • 2600Vac for 60sec(AC TYPE)(For Lead Pitch=7.5&10mm)
  • 4000Vac for 60sec(AH,AS TYPE)(For Lead Pitch=10&12.5mm)

WALSIN HIGH ENERGY (E SERIES) MOV VARISTORS

  • Storage Temperature : -40°C to +125°C
  • Operating Ambient Temperature : -40°C to +85°C (without derating)
  • Maximum Voltage-Temperature Coefficient : < -0.05% / °C
  • Insulation Resistance : 1000 Mega-ohm minimum
  • Hi Pot (Leads To case, 1 Min.) : 2500 VDC
  • Typical Response Time : <25 Nano-seconds
 Epoxy Rating : 94V-0
 Current / Energy Derating (>85°C ) : -2.5% / °C
  • DC Leakage Current : 200μA maximum (at rated DC working voltage )
  • Solderability : MIL-STD-202F
1 - 24 of 45

Recent Updates